Fully-Fabricated 3" Lift Spindle
| 
| Hits: 1955
Fully-Fabricated 3” Lift Spindles
Solo Motorsports is proud to offer our Fully-Fabricated 3” Lift Spindles for early model two-wheel drive 96-04 Tacomas, 00-06 Tundras, and 96-02 4Runners. Over 20 years of desert racing fabrication and experience went into the design of our 3” Lift Spindles. Solo Motorsports’ built 3” Lift Spindles are CNC machined from high-grade U.S. steel with a “boxed” high-strength design resulting in a spindle with an off-set of 1 7/8” wider stance per side. This wider stance will eliminate the need for wheel spacers for the guys who want that “Prerunner Look” or for the long travel guys who are seeking to improve desert handling. 12-point grade 8 hardware is used to secure the CNC machined hubs along with grade 8 hardware for the lower spindle attachment. Any aftermarket orSolo Motorsports’ built UCA, upper control arm, with a 1”uniball is necessary.
Our 3” Lift Spindles will work with any factory coilover shock with or without a spacer or aftermarket coilover shock. When our 3” Lift Spindles are used in conjunction with your long travel front suspension, less or relaxed coilover pre-load will result in an improved smoother ride on road and an off road driving experience that’s dramatically improved over the small to medium roller-bumps. To protect the 3” Lift Spindles from the elements, they are powdercoated flat black.
Full factory steering is retained along with higher ground clearance. All 3” Lift Spindles come with new unit hub bearings pre-installed at our facility allowing for an easy bolt-on installation in a little over an hour with basic hand tools or a few hours when a new UCA is added..
Finally, as an upgrade for the hardcore desert racing enthusiasts, we are proud to offer a Fully-Fabricated 1” Lower Uniball/Steering Conversion with 7/8” outer heim joints that are double-sheared. Billet steering connectors to the rack and pinion are also included
Longer brakelines will be required for either a UCA or long travel setup. Also, depending on your UCA manufacturer, a new grade 8 hardware kit maybe required. There is a hub core charge of $300 that’s required or drop off your stock spindles/hubs .
Model Applications:
'96-'04 Tacoma
'00-'06 Tundra
'96-'02 4Runner
Category: